Bosch DS7200V2-EXP Guide de l'utilisateur télécharger pdf (Page 89)

DS7200V2-EXP | Expert Programming Guide | 4. Control Panel Programming EN | 89

Bosch Security Systems | 8/04 | 4998153891C

Zone Wiring Configuration

The operation and configuration of the zone function depends on the method of zone wiring. A zone is a “Single

EOL resistor” zone if the zone is supervised with one end of line resistor. Table 18 defines configuration options

for single EOL resistor zones.

Table 18: Single EOL Resistor Zone Configuration Options

Device Selection as

shown in Table 13

Address for Zone Wiring

Configuration Options

Configuration

Options

1 1026 1, 2, 3

2 1257 to 1261 4 to 11

4 or 5 1249 4 to 7

For On-board zones, device is 1. See On-board Location EOL Resistor Value on page 103.

For Wired-Expander zones, device is 2. See DX2010 Configuration Options on page 127.

For RF zones, Device is 4 or 5. See RF Receiver Configuration on page 123.

Tamper-wired zones, Zone-doubled zones, or No EOL resistor zones function differently. These non-single EOL

resistor zones are defined by the configuration options shown in Table 19.

Table 19: Tamper-wired, Zone Doubled, and No EOL Resistor

Zone Configuration Options

Device Selection as

shown in Table 13

Address for Zone Wiring

Configuration Options

Configuration

Options

1 1026 0, 4, 5, 6

2 1257 to 1261 0 to 3

3 N/A Always

4 or 5 1249 0 to 3

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 155 156

Pas de commentaire

Bosch DS7200V2-EXP Guide de l'utilisateur Page 89