Bosch DS7200V2-EXP Guide de l'utilisateur télécharger pdf (Page 37)

DS7200V2-EXP | Expert Programming Guide | 4. Control Panel Programming EN | 37

Bosch Security Systems | 8/04 | 4998153891C

4.2.7 Global Open/Close Options

Arming Options 1

• Address: 0258

• Default: 0

• Selections: 0 to 7

Enter This Data Digit to Select Options

Arming Options 1 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

No Options Enabled

•

Enable All On-No Exit

• • • •

Answering Machine Bypass only when All/Perimeter

Only On

• • • •

Remote Arming with Telephone, Area 1

• • • •

Reserved

• Enable All On-No Exit: If this option is enabled and the system is turned All On and no Entry/Exit Delay

zones are faulted during Exit Delay, the system automatically shifts to Perimeter Only. Perimeter Only (not

All On) appears in the log and reports. This option can only be used if the control panel is armed with delay.

This option does not apply when arming with keyswitches or RF keyfobs.

• Answering Machine Bypass Only When All On/Perimeter Only On: If this option is enabled, the

Answering Machine Bypass function is activated at RPS Answer Ring Count, Answering Machine Bypass

parameter (see page 17). If activated there, this option can be used to restrict its function so that it only

operates when the system is All On or Perimeter Only On. The system does not answer if disarmed.

• Remote Arming with Telephone, Area 1: If enabled, this option controls the built-in telephone arming

feature for Area 1. When enabled, the control panel answers the phone on the ring count for remote

programming. The following occurs when the control panel answers the phone:

− If the control panel is All On or Perimeter Only On, it sounds three beeps and starts the handshake tone

for remote programming.

− If the control panel is Off, it sounds one short beep, waits approximately three sec and then starts the

handshake tone for remote programming (one long beep). Press and hold [5] for two sec immediately

after the first short arming beep and before the handshake tone begins.

If arming from a cell phone, quickly press [5] three times. If pressing and holding [5] for two sec from a

house (landline) phone does not produce a tone long enough to arm Area 1, retry by quickly pressing [5]

three times.

− The control panel arms if it detects a [5] key press from the telephone (All On with Delay, faulted zones

are force-armed like keyswitch arming). The control panel sounds three beeps (new armed state) and then

hangs up.

You cannot use a telephone to disarm the control panel.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 155 156

Pas de commentaire

Bosch DS7200V2-EXP Guide de l'utilisateur Page 37