Bosch DS7200V2-EXP Guide de l'utilisateur télécharger pdf (Page 118)

DS7200V2-EXP | Expert Programming Guide | 4. Control Panel Programming EN | 118

Bosch Security Systems | 8/04 | 4998153891C

Table 26: Output Mode Options (continued)

Mode Mode Type Output

Type

Description

State Output turns off when the condition is active and remains off until [System Reset] is

pressed.

9 Latch,

Reversed

Logic Normal

Event Output turns off when the event occurs and remains off until [System Reset] is

pressed.

State When the condition is active, the output pulses. When the condition is inactive, the

output is on.

10 Pulse,

Reversed

Logic Normal

Event When the event occurs, the output pulses. The output continues pulsing until [System

Reset] is pressed, then turns on.

State When the condition changes from inactive to active, the output turns off. The output

turns on at the end of the One-Shot time. While the output is off, any changes in the

condition are ignored.

11 One-Shot,

Reversed

Logic Normal

Event When the event occurs, the output turns off and remains off for the One-Shot time.

While the output is off, a second event does not affect the output.

State When the condition changes from inactive to active, the output turns off and remains

off for the One-Shot time. If the condition goes inactive and active again, the One-Shot

time is restarted and the output remains off.

12 One-Shot

with Re-

Trigger,

Reversed

Logic Normal

Event When the event occurs, the output turns off and remains off for the One-Shot time. If a

new event occurs, the One-Shot time is restarted and the output remains off.

State When the condition changes from inactive to active, the output turns off and remains

off for the One-Shot time. If the condition goes inactive, the output is turned on early.

13 One-Shot

with Reset,

Reversed

Logic Normal

Event When the event occurs, the output turns off and remains off for the One-Shot time.

[System Reset] turns the output on early.

Base, Output ##

• Address: See Table 24 on page 110

• Default: 0 (Disabled)

• Selections:

− 0 = Disabled

− 1 = 200 ms (on-board outputs only)

− 2 = 1 second

− 3 = 1 minute

− 4 = 1 hour

Multiply the Base with the Multiplier to determine the output’s timing. See Table 27, on page 119, and Table 28, on

page 119.

Multiplier, Output ##

• Address: See Table 24 on page 110

• Default: 0,0 (Disabled)

• Selections: 0,0 to 9,9

Multiply the Base with the Multiplier to determine the output’s timing. See Table 27, on page 119, and Table 28, on

page 119.

1 2 ... 113 114 115 116 117 118 119 120 121 122 123 ... 155 156

Commentaires sur ces manuels

Pas de commentaire

Bosch DS7200V2-EXP Guide de l'utilisateur Page 118

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Bosch DS7200V2-EXP