Bosch DS7200V2-EXP Guide de l'utilisateur télécharger pdf (Page 123)

DS7200V2-EXP | Expert Programming Guide | 4. Control Panel Programming EN | 123

Bosch Security Systems | 8/04 | 4998153891C

4.8 Data Bus Device Parameters

The following parameters configure devices that connect to the control panel’s Data Bus.

4.8.1 RF Receiver Configuration

RF Receiver Options

• Address: 1249

• Default: 0

• Selections: 0 to 7

Enter This Data Digit to Select Options

Premises RF Receiver Options 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

No RF Receiver Connected

•

RF Receiver 1 connected, set to Address 50

• • • • • • • •

RF Receiver 2 connected, set to Address 51

• • • • • • • •

Disable RF Loop Tamper

• • • • • • • •

Keyfobs Do Not Force Arm Faulted Zones

• • • • • • • •

• RF Receiver 1 Connected, Set Receiver to Address 50: Enable this option if RF Receiver 1 has been

connected to the control panel. Set the RF receiver’s address to 50 (jumper setting OFF). See “Adding RF ID

Codes” in the DS7200V2 Installer’s Guide (P/N: 4998153893) for instructions. See RF Transmitters and Zone

States on page 87 for details on RF transmitters and zone states.

All status reports for the RF Receiver include the address. For example, if the cover is removed, Event {127}

(DBus Tamper) is generated.

• RF Receiver 2 Connected, Set Receiver to Address 51: Enable this option if RF Receiver 2 has been

connected to the control panel. Set the RF receiver’s address to 51 (jumper setting ON). See “Adding RF ID

Codes” in the DS7200V2 Installer’s Guide (P/N: 4998153893) for instructions. See RF Transmitters and Zone

States on page 87 for details on RF transmitters and zone states.

All status reports for the RF Receiver include the address. For example, if the cover is removed, Event {127}

(DBus Tamper) is generated (the address is included in the report).

• Disable RF Loop Tamper: The RF3401E transmitter’s loop can be wired with a single 2.2 k EOL resistor, or

it can be wired with dual 2.2 k EOL resistors. If this option is enabled, wire the RF3401E with a single 2.2 k

EOL resistor. The loop can report as normal, shorted, or open. If this option is disabled, wire the RF3401E is

with dual 2.2 k EOL resistors. The loop can report as normal, shorted, faulted, or open.

• Keyfobs Do Not Force Arm Faulted Zones: If this option is enabled, arming from a keyfob does not force

arm faulted zones. A faulted zone prevents the area from arming. If this option is disabled, arming from a

keyfob does force arm faulted zones.

1 2 ... 118 119 120 121 122 123 124 125 126 127 128 ... 155 156

Pas de commentaire

Bosch DS7200V2-EXP Guide de l'utilisateur Page 123