Bosch DS7200V2-EXP Guide de l'utilisateur télécharger pdf (Page 38)

DS7200V2-EXP | Expert Programming Guide | 4. Control Panel Programming EN | 38

Bosch Security Systems | 8/04 | 4998153891C

Arming Options 2

• Address: 0259

• Default: 12

• Selections: 0 to 15

Enter This Data Digit to Select Options

Arming Options 2 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

No Options Enabled

•

First Area to Open/Last Area to Close Reporting

• • • • • • • •

Make Area 1 Common Area

• • • • • • • •

Enable All Areas All On ([#][8][0])

• • • • • • • •

Enable All Areas All Off ([#][8][1])

• • • • • • • •

• First Area to Open {164}/Last Area to Close {165} Reporting: If this option is enabled, the system sends

one Closing {165} report when all areas are turned On and one Opening {164} report when any area is turned

Off. Opening/Closing reports must be enabled for all areas.

Enabling the “Restrict Open/Close Reports” option overrides the “First Area to Open/Last Area to

Close Reporting” option. See Area # Opening {89-96}/Closing {42-67} Reporting Options on page 49

for more information on the “Restrict Open/Close Reports” option.

All area account numbers must be the same in order to send Area 1’s account numbers. See Area

Wide Parameters on page 48 for account number programming instructions.

• Make Area 1 Common Area: If this option is enabled, all other areas are made common to Area 1. Area 1

arms when all the other areas are armed All On, and Area 1 disarms when any other area is disarmed.

• Enable All Areas All On ([#][8][0]): If this option is enabled, all areas arm when a user enters [#][8][0].

Faulted zones are force-armed. Enable all areas in which the user has the appropriate authority level.

• Enable All Areas Off ([#][8][1]): If this option is enabled, all areas disarm when a user enters [#][8][1]. This

function always requires a PIN. Enable all areas in which the user has the appropriate authority level.

Bypass/Force Arm Limit

• Address: 0260

• Default: 7

• Selections: 0 to 15

The parameter configures all areas.

This parameter sets the maximum number of zones that can be force-armed or bypassed for any one area. The

area does not arm if the number of faulted zones exceeds this limit.

Entering zero (0) allows an unlimited number of zones to be force-armed or bypassed.

The Zone Function determines which zones are bypassable.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 155 156

Pas de commentaire

Bosch DS7200V2-EXP Guide de l'utilisateur Page 38