Bosch DS7200V2-EXP Guide de l'utilisateur télécharger pdf (Page 83)

DS7200V2-EXP | Expert Programming Guide | 4. Control Panel Programming EN | 83

Bosch Security Systems | 8/04 | 4998153891C

Location ##, Device

• Address: See Table 13 on page 80

• Default: See Table 13 on page 80

• Selections:

− 0 = No Device Assigned (Disabled)

− 1 = On-board Zone (L-1 to L-8)

− 2 = Wired Zone Expander (DX2010) (configured for 8 inputs)

− 3 = Wired Zone Expander (DX2010) (configured for 16 inputs [zone doubled])

− 4 = RF Receiver 1 (see RF Receiver Configuration on page 123)

− 5 = RF Receiver 2 (see RF Receiver Configuration on page 123)

− 6 = DACM Door Contact (see DACM Configuration on page 135)

Each location in the control panel can be assigned to one of four types for devices:

• The control panel’s on-board sensor loops (L-1 to L-8)

• A DX2010 Input Expander

• A Data Bus RF Zone Expander (Receiver 1 or Receiver 2)

• A DACM’s door contact

Use each location’s Device parameter to assign the location to a device type.

You must exit control panel programming in order to enter the RF ID code. Add RF ID codes after you complete

your programming session. See “Adding RF ID Codes” in the DS7200V2 Installer’s Guide (P/N: 4998153893) for

complete instructions.

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 155 156

Pas de commentaire

Bosch DS7200V2-EXP Guide de l'utilisateur Page 83