Bosch DS7400XiV4-EXP Spécifications télécharger pdf (Page 30)

DS7400XiV4-EXP | Reference Guide | 5.0 Programming the Control Panel EN | 30

Bosch Security Systems | 1/05| 4998154963B

5.8 General Control Panel Programming

General control panel programming defines the system-wide general operating parameters. See the Glossary

(Section 7.2.1 General Control Programming) for more information.

• Address: 0000

• Data Digit:

• Data Digit 1: ____ (see Table 15; default = 1)

• Data Digit 2: ____ (see Table 16; default = 3)

• Selections: 0 to 9, *0 to *5 (hexadecimal values that display as A through F at the keypads)

Table 15: General Control Programming (Address 0000, Data Digit 1)

Selections for Data Digit 1

Select Options 0 1 2 3 4 5 6 7 8 9 *0 *1 *2 *3 *4 *5

Allow Normal and Custom Arming

• • • •

• • • • • • • • • • • •

Allow Perimeter Instant Arming

• •

Allow Perimeter Arming

• •

Allow Maximum Security Arming

• •

Closing Ring-Back

• • • •

Siren on Comm. Fail for Silent Zone

• • • •

50 Hz Operation

•

60 Hz Operation

•

Table 16: General Control Programming (Address 0000, Data Digit 2)

Selections for Data Digit 2

Select Options 0 1 2 3 4 5 6 7 8 9 *0 *1 *2 *3 *4 *5

Restore Zone When Sounders Silence

•

Restore Zone When Zone Restores

•

Restore Zone When System is Disarmed

•

Allow Swinger Shunts. Send Bypass Reports

•

• •

Allow Swinger Shunts. No Bypass Reports

• • •

See the following:

• Normal Arming = [PIN][On]: If programmed, Normal Arming arms the entire system while

allowing entry delays for entry/exit zones.

• Perimeter Instant Arming = [PIN][No Entry][Perimeter Only]: If programmed, Perimeter Instant

Arming arms only the perimeter of the system and does not allow entry delays for entry/exit zones.

• Perimeter Arming = [PIN][Perimeter Only]: If programmed, Perimeter Arming arms only the

perimeter of the system while allowing entry delays for entry/exit zones.

• Custom Arming = [PIN][#][4]: If programmed, Custom Arming allows custom arming of the system

and bypasses the zone functions specified in Program Addresses 2725-2728.

• Maximum Security Arming = [PIN][No Entry][On]: If programmed, Maximum Security Arming

arms the entire system and does not allow entry delays for entry/exit zones.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 143 144

Commentaires sur ces manuels

Pas de commentaire

Bosch DS7400XiV4-EXP Spécifications Page 30

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Bosch DS7400XiV4-EXP