Bosch B450 Guide d'installation télécharger pdf (Page 59)

Zone

indicator

Fault description Button Zone

indicator

Fault condition

2 Receiver 2 fail

3 IP module 1 fail

4 IP module 2 fail

7 Output and codepad

fail

7 2 Output expander fail

3-6 Codepad fail

8 Keyfob low battery 8 1-16 Keyfob 1 to 16 low battery

Fault descriptions

1 – System Fault

The system FAULT indicator lights when any of the faults listed in the table System FAULT

Indicators below occurs. In Fault Analysis Mode, press [1] to determine the fault that

occurred.

2 – RF Device Low Battery

This fault occurs when any of the RF wireless devices report a low battery condition to the

control panel. While in Fault Analysis Mode, press the [2] key. This displays the zone reporting

the RF Low Battery fault.

3 – Zone Tamper Fail

This fault occurs when any zone with tamper becomes an open or short circuit. Press the [3]

key until. This displays the zone reporting the tamper fail fault.

4 – Sensor Watch Fault

A sensor watch fault registers because one or more detection devices failed to detect any

movement during the disarmed state for the time programmed in Locations 476 and 477(refer

to Sensor Watch Report, page 142). The fault clears once the zone in question detects

movement and resets. Press the [4] key. This displays the zone reporting the sensor watch

fault.

5 – RF Sensor Missing

An RF sensor missing registers because one or more RF detection devices fails to

communicate to the RF radio receiver for the time period programmed in Location 393 RF

Supervision Time. The fault clears once the RF device in question successfully transmits to the

RF radio receiver.

While in Fault Analysis Mode, press the [5] key. This displays the RF detection device

reporting the RF sensor watch fault.

6 – Communication Fail

A communication fail registers when the control panel fails to communicate with the receiving

party (such as a monitoring company, mobile phone). The communication fault clears once the

control panel successfully reports to the receiving party.

A communication fail also registers when network module is disconnected or tampered.

To determine which receiver or module failed to communicate, press the [6] key.

In Fault Analysis Mode, press [6] to show which communication fault occurred: 1 – Receiver 1;

2 – Receiver 2.

7 – Output and Codepad Fail

The output fault registers when the output expander B308 is disconnected or tampered.

6.15

Control Panel System Operations | en 59

Installation Guide 2014.07 | 00n | F01U298026

1 2 ... 54 55 56 57 58 59 60 61 62 63 64 ... 151 152

Commentaires sur ces manuels

Pas de commentaire

Bosch B450 Guide d'installation Page 59

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Bosch B450