Bosch DS7445 Guide de l'utilisateur Page 8

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 40
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 7
Page 8
NOTE: In commercial burglar alarm applications for UL Listed Requirement systems, a ring-back indication and bell test should be heard after
arming (closing). If not heard, call for service.
If this is a Partitioned system, please read “Understanding Partitioning” on page 6 of this guide before using this chart.
Turning ON (arming) your System (continued)
What to DoType of Arming Desired
Perimeter Arming
Someone still on the
premises.
The entry/exit delay
is in effect.
A single beep will sound.
The red Armed Light will begin to flash.
Perimeter On will be displayed.*
Exit Now will be displayed during the exit delay interval.*
The red Armed Light will turn on steady after the exit delay
expires.
The yellow Perimeter Light will turn on steady after the
exit delay expires.**
Only exterior protection zones will be armed.
Custom Arming
(If programmed)
Ask your installing company
to explain the type of arming
that occurs when using this
command.
A single beep will sound.
The red Armed Light will begin to flash.
On Partial will be displayed.*
Exit Now will be displayed during the exit delay interval.*
The red Armed Light will turn on steady after the exit delay
expires.
Some zones will be bypassed.
Maximum Security
Arming
No one left on the premises.
There is NO entry delay in
effect. An alarm WILL occur
upon entry.
A single beep will sound.
The red Armed Light will begin to flash.
The green Status Light will turn off.
Armed Instant will be displayed.*
Exit Now will be displayed during the exit delay interval.*
The red Armed Light will turn on steady after the exit delay
expires.
* = DS7447 only
** = DS7443S & DS7445 only
What will Happen
Command
Sequence***
PIN +
[Perimeter Only]
PIN + [#] + [4]
PIN + [No Entry]
+ [On]
Move freely
around the
interior.
Exit during the
exit delay
interval.
Exit during the
exit delay interval.
CAUTION:
Violating any zone
after the exit delay
will cause an
instant alarm.
*** = If in Residential Mode, a PIN is not required for these commands.
Vue de la page 7
1 2 3 4 5 6 7 8 9 10 11 12 13 ... 39 40

Commentaires sur ces manuels

Pas de commentaire