Bosch DS7445 Guide de l'utilisateur télécharger pdf (Page 10)

Page 10

This chart explains proper procedures for disarming and/or silencing alarms.

Please read the section about Emergency Procedures prior to being confronted with an emergency event.

If you have entered the building through a perimeter door, you may hear a steady pre-alert tone from the keypads. If so, disarm according to the

chart below.

If the bells and sirens are on and/or the red Armed Light is flashing, then the keypad is signaling that an alarm has occurred

sometime before your arrival. The DS7447 will display “Zone Alarm”. The DS7443S zone LEDs (1-6) (Zones 7 & 8 will not be

displayed) or the DS7445 zone LEDs (1-8) will be flashing for the corresponding zone that is in alarm.

• The keypad will also issue a pulsed tone during the entry delay instead of the usual steady tone.

• If the alarm has not been previously investigated, do not enter the building unless accompanied by the appropriate

Emergency Services’ personnel.

Turning OFF (disarming) your System / Silencing Alarms

* In non-partitioned systems. For systems with partitioning, review “Understanding the Keypads” on page 4 and “Understanding Partitioning”

on page 6.

Disarming the

System

The red Armed Light will turn off.

Pre-alert sounders will silence.

Action Desired Command Sequence What will Happen *

Silencing Alarms

The red Armed Light will turn off.

Zone LEDs (1-8) on the DS7445 will turn off.

Alarms in progress will silence.

PIN + [Off]

Zone LEDs (1-6) on the DS7443S will turn off.

(Zones 7 & 8 are not displayed)

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 39 40

Pas de commentaire

Bosch DS7445 Guide de l'utilisateur Page 10