Bosch DS7445 Guide de l'utilisateur télécharger pdf (Page 28)

Page 28

Personal Identification Numbers (continued)

This chart will guide you through the steps necessary to change a PIN.

You should write down your entries before you enter the Master Code Programming Mode and have them with you as you begin programming.

Make your entries promptly. If a long delay occurs in your entries, the 3-beep error tone occurs and exits you from the programming mode.

# 1. Enter the Master Code

Programming Mode.

“0 User Change”

(display will scroll to this)

[Master Code] + [#] [0]

Steps to Change a

Command

Sequence

If Accepted, DS7447 Display Reads

# 2. Enter a 0.

[0]

“Enter User No.”

(001..0XX)

# 3. Enter the User Number.

[0] [0] [1]

through

[0] [1] [5]

“Enter Authority Level”

Level (0-6)

# 4. Enter the Authority Level.

[0] through [6]

“Enter PIN”

# 5. Enter the PIN.

Any

digits.

Do not press [#].

# 6. Enter the PIN again followed by

the [#] key.

PIN (same 4 digits as above),

then [#].

A long beep will sound to signify

acceptance of the new PIN.

“Enter PIN Again. End with #”

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 39 40

Pas de commentaire

Bosch DS7445 Guide de l'utilisateur Page 28