Bosch DS7445 Guide de l'utilisateur télécharger pdf (Page 32)

Page 32

Testing Your System (continued)

This chart explains the procedure for performing a Communicator Test.

This test is available only if your system transmits alarms and system information to a monitoring service, and has been programmed by the

security installing company to permit communicator tests.

A long beep will initially sound to acknowledge the start of the test.

If the test is successful, the sounder will again issue one long beep.

If the test fails, the keypad sounder will turn ON continuously. To silence the sounder, enter you PIN followed by the [#] key or press the [*] key.

Type of Test

Command

Sequence**

What to Do

Communicator

Test

• A long beep will sound.

• A "Test" report is sent to the monitoring

service.

If test fails, the keypad sounder

will sound continuously. To

silence the sounder, enter your

PIN followed by the [#] key or the

[*] key.

Note:

This test may take several

minutes to complete because the

control panel will try 10 attempts

before it fails this test.

What will Happen

PIN + [#] [8] [2]

** = If in “Residential Mode”, a PIN is not required for this command.

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 38 39 40

Pas de commentaire

Bosch DS7445 Guide de l'utilisateur Page 32