Bosch DS7445 Guide de l'utilisateur télécharger pdf (Page 29)

Page 29

Error Displays

This chart explains the procedure for reading Error messages when the green Power Light is flashing.

Control panel problems are indicated by a flashing green Power Light and the DS7447 display reading “Control Trouble, Enter #87.”

Error messages may only be read when the control is disarmed. Contact your installing company if the problems persist.

1. “AC Power Failure”* or LED #1 on steady**: There is a power failure

and the control panel is running on backup battery.

2. “Battery Trouble”* or LED #2 on steady**: If the system has just

been through a power failure, wait at least two hours for the battery

to recharge, then enter a PIN + [System Reset] to perform a battery

test.

3. “Communicator Err”* or LED #3 on steady**: The communicator

failed to communicate with the central station.

4. “System Fault”* or LED #4 on steady**: Internal error in the control

panel’s circuitry or optional circuitry. These faults are designated as

follows:

5. “Keypad Fault”* or LED #5 on steady**: One of the keypads is not

responding to the control panel.

6. “Aux Power Fault”* or LED #8 on steady**: The Auxiliary power has

been shorted.

7. “Zone Trouble”* or LED #6 on steady**: One or more of the zones is

not responding to the control panel. This may also display during

power-up (if so, ignore).

* = the DS7447 display

** = the DS7443S and DS7445 displays

*** = If in “Residential Mode”, a PIN is not required for these commands.

**** = Battery Trouble and Communicator Err displays must be cleared by the

[System Reset] command sequence even after the problem has been remedied.

These displays will not self clear.

All the other error displays will self clear from the keypads once the problem has

been remedied.

Command

Sequence***

Action Desired

Read the Error Display when the

green Power

Light is flashing

Clear the Error Display

****

Caution:

Clear the error display

only on the advice of your installing

company or if you are certain the

problem has been remedied.

PIN + [#] [8] [7]

PIN + [System Reset]

[#] [8] [9]

will d ispla y

[#] [8] [7]

will dis play

System Fault 01

System Fault 02

System Fault 03

System Fault 05

RAM Fault

ROM Fault

EEPROM Fault

TRBL Zone Fault

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 39 40

Commentaires sur ces manuels

Pas de commentaire

Bosch DS7445 Guide de l'utilisateur Page 29

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Bosch DS7445