
Page 13
Chime Mode
This chart explains the procedure for turning ON and turning OFF Chime Mode.
Chime Mode causes all the keypad sounders to beep each time a Perimeter or Entry/Exit zone is violated while the control panel is off (disarmed).
The [#] [7] command is used to both turn Chime Mode off and on.
You cannot set the Chime mode by partition.
Command
Sequence*
Action Desired What will Happen
Turn ON
Chime Mode
The keypad sounders will beep for two seconds
each time a Perimeter or Entry/Exit zone is violated.
The DS7447 display will read
“
Chime Mode On
” for 5 seconds.
Turn OFF
Chime Mode
The DS7447 display will read
“
Chime Mode Off
” for 5 seconds.
PIN + [#] [7]
PIN + [#] [7]
* = If in “Residential Mode”, a PIN is not required for these commands.
Commentaires sur ces manuels