Bosch DS7445 Guide de l'utilisateur télécharger pdf (Page 30)

Page 30

Testing Your System

This chart explains the procedure for performing a Zone Test.

It is recommended that the system be tested weekly.

The Zone Test is used to confirm that detectors will report alarms to the keypad.

A Zone Test works on all zones, except 24-hour zones and fire zones.

While the keypad is in a Zone Test, no control panel alarms will activate an alarm, except 24-hour zone alarms and fire alarms; these will override

the Zone Test function.

Test each detector one at a

time as instructed by the

installing company.

To exit the Zone Test mode,

enter your PIN followed by

the [#] key.

Zone Test

Type of

Test

What will Happen

Command

Sequence*

What to Do

PIN + [#] [8] [1]

The DS7443S and DS7445 keypads will flash the zone

LEDs of any untested zones. The DS7443S cannot

display zones 7 & 8.

The DS7443S and DS7445 will turn the zone LED on

steady for the zone that is currently being violated (tested).

The DS7443S cannot display zones 7 & 8.

* = If in “Residential Mode”, a PIN is not required for this command.

“Test Zone” will display on the DS7447 followed by

the zone number of any zones that have not been

tested.

“Now Testing” will display on the DS7447 followed by

the zone number of the zone that is currently being

violated (tested). It returns to “Test Zone” after the

violation.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 39 40

Pas de commentaire

Bosch DS7445 Guide de l'utilisateur Page 30