Bosch DS7445 Guide de l'utilisateur télécharger pdf (Page 26)

Page 26

Personal Identification Numbers

General Information

When programing Personal Identification Numbers, it is helpful to know

the following terms:

• PIN: Personal Identification Number. This is the 4 or 6 digit code

users enter at the keypad to gain access to the system. A PIN may

be assigned to each User Number 001 - 015.

• Partition (Area): This is the area the User has authority in. You may

select Partition (Area) 1, 2 or both.

• User Number: This is the number that identifies each person using

the system. There are 15 possible User Numbers (001 - 015).

• Authority Level: This number determines which functions each user

will be able to perform (see page 27).

Your system has the capacity to assign up to 15 PINs. The length of

the PINs will be fixed at 4 or 6 digits. You cannot have both 4 and 6 digit

PINs in the same system. If you wish to change the PIN length, it will

be necessary to have your installing company make the change. If

changed, all new PINs will need to be assigned. Each User number

may have only one PIN assigned to it. Attempting to assign the same

PIN to multiple User Numbers will result in a 3 beep entry error tone,

and the entry will not be made.

User Number 001 is designated as a Master Code. It can be used to

add, delete or change other PINs.

User Number 001 is shipped from the factory with the sequence of

123456. This code should be changed to one of your personal

preference, and must be programmed as a Master Code. PINs should

never be programmed with common sequences such as 1111 or 2468

because they are easily violated.

Removing a PIN

To remove a PIN: enter a [Master Code] [#] [0] [0], the User Number of

the PIN to be canceled, and then [#] again.

User Number 001 can not be canceled in this manner.

continued on next page

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 39 40

Pas de commentaire

Bosch DS7445 Guide de l'utilisateur Page 26