
Page 7
Turning ON (arming) your System
This chart explains the five normal ways to arm the system.
The green Status Light must be on steady and the display* must read “Ready to Arm” in order to arm the system with one of these commands.
If the green Status Light is not on, or if the display* is reading “Not Ready, ”then see Force Arming or Zone Bypass for other ways to arm the
system.
If this is a Partitioned system, please read “Understanding Partitioning” on page 6 of this guide before using this chart.
NOTE: In commercial burglar alarm applications for UL Listed Requirement systems, a ring-back indication and bell test should be heard after
arming (closing). If not heard, call for service.
*** = If in “Residential Mode”, a PIN is not required for these commands.
Type of Arming Desired
Exit during the
exit delay
interval.
Normal Arming
No one left on the
premises.
An entry/exit delay
is in effect.
Perimeter Instant
Arming
Someone still on the
premises.
There is NO entry delay
in effect.
Move freely
around the
interior.
PIN + [On]
PIN + [No Entry] +
[Perimeter Only]
• A single beep will sound.
• The red Armed Light will begin to flash.
• The green Status Light will turn off.
• “Armed” will be displayed.*
• “Exit Now” will be displayed during the exit delay interval.*
• The red Armed Light will turn on steady after the exit delay
expires.
Command
Sequence***
• A single beep will sound.
• The red Armed Light will begin to flash.
• “Perimeter Inst.” will be displayed.*
• “Exit Now” will be displayed during the exit delay interval.*
• The red Armed Light will turn on steady after the exit
delay expires.
• The yellow Perimeter Light will turn on steady after the
exit delay expires.**
• Only exterior protection zones will be armed.
What to Do
* = DS7447 only
** = DS7443S & DS7445 only
What will Happen
Commentaires sur ces manuels