Bosch DS7445 Guide de l'utilisateur télécharger pdf (Page 23)

Page 23

Fire Reset / Fire Trouble

Fire Reset

During a fire alarm, exit the premises immediately. When you have de-

termined there is no fire, it is recommended that you silence the bells/

sirens before you initiate the [System Reset] command.

Before the [System Reset] command is used, deter-

mine which smoke detector has alarmed so the in-

stalling company may verify its operation.

A PIN followed by the [System Reset] key will reset any

smoke detectors after a fire alarm has occurred.

PIN + [System Reset]

NOTE: To use the System Reset command sequence, your

PIN must have disarm privileges.

The System Reset command will perform a fire reset, will

perform a battery test, and will clear all system troubles.

Fire Trouble

A Fire Trouble display signifies a problem with the fire system, such as

a break in the wiring that monitors smoke detectors.

A Fire Trouble will be indicated by a short beep from the keypad sound-

ers every 10 seconds. The DS7447 keypad will display “Fire Trouble”

followed by the zones in a trouble condition.

The DS7443S and DS7445 keypads will turn the Fire and Trouble Lights

on steady and will light the corresponding zone LEDs.

Notify your installing company immediately if the Fire Trouble message

is displayed.

The Fire Trouble beep can be silenced with any PIN followed by the

[Off] key. After problems have been remedied, a PIN followed by

[System Reset] should be entered to clear the “Fire Trouble” display.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 39 40

Pas de commentaire

Bosch DS7445 Guide de l'utilisateur Page 23