Bosch LTC 8500 Manuel d'instructions télécharger pdf (Page 34)

EN | 24 Bosch Security Systems | December 13, 2005

desired, a few extra camera number lines in the table may be reserved at this time

for future expansion. If a local title is specified, the camera's title can also be entered

at this time. Designate any local camera numbers appropriately, and enter their cor-

responding titles.

Figure 8: Main Site Sample Program Showing Local Cameras, Trunk Lines and Remote Cameras

NOTE Either a local camera, or a remote camera programmed with a local title, will

need to be selected to view certain on-screen prompts or data during program-

ming of the main site via a system keyboard.

Once the system is programmed and configured, any unused monitor outputs

located at the main site should be selected to display a local camera via the system

keyboard. This prevents unused monitor outputs from using up trunk lines which

may result in some confusing operational responses.

The “Start-up” camera numbers listed in the Monitor Table of the LTC 8059/00

software should be programmed to specify locally connected cameras or a local

unused input (i.e., the raster generator will be displayed when called up). This table

defines the camera numbers that will automatically be switched to an operator's

monitor in the event the trunk line being used to display their original satellite cam-

era is 'stolen' by an operator with a higher priority.

Figure 9: Main Site Sample Program Showing Monitor Start-Up Camera Numbers

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 103 104

Pas de commentaire

Bosch LTC 8500 Manuel d'instructions Page 34