Bosch LTC 8500 Manuel d'instructions télécharger pdf (Page 62)

EN | 52 Bosch Security Systems | December 13, 2005

Programming a SalvoSwitching Camera Sequence

A SalvoSwitching sequence can be used to switch a group of monitors simulta-

neously as a synchronized group. To program a Salvo sequence, enter the program-

ming mode as described above for a simple camera sequence. By definition, Salvo

sequencing involves more than one monitor. An example of a simple Salvo

sequence that switches cameras on three (3) monitors simultaneously is shown

below:

In general, follow the instructions used for the simple camera sequence (described

above), but instead of entering a number of seconds for steps that must switch

instantly, enter 61 and press [Enter]. This causes the switcher to automatically

change to the salvo abbreviation SLV. Dwell time (in seconds) is entered only when

you reach the step containing the last monitor that will be switched within the syn-

chronized group.

CAMERA MONITOR DWELL

1 1 SLV

2 2 SLV

3 3 2

7 1 SLV

8 2 SLV

9 3 2

21 1 SLV

22 3 SLV

23 3 2

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 103 104

Pas de commentaire

Bosch LTC 8500 Manuel d'instructions Page 62