Bosch LTC 8500 Manuel d'instructions télécharger pdf (Page 27)

Video Output Modules

EN | 17

7. 3Video Output Modules

Counting from left to right beginning with slot 9, install the appropriate number of

Video Output Modules (VOM) into these slots. If fewer than the maximum number

of VIMs are installed, there will be empty slots between the Input and the Output

Modules, so make sure that the Output Modules are inserted into the correct slots.

Figure 4: Typical Video Output Module Insertion

All VOMs are identical and are interchangeable within the designated VOM slots.

7. 4CPU Module

The slot to the left of the power supply in the main CPU bay is reserved for the sys-

tem CPU module.

NOTE The CPU module contains two (2) lithium batteries mounted on the component

side of the printed circuit board. A red rectangular insulating tag may be

installed in between the top of the batteries and the battery holder clip. This tag

prevents battery drainage during stocking. Remove tag if so equipped.

Figure 5: Typical CPU Module Insertion

Install the main bay CPU at this time.

The circuit board contains two (2) 8-position DIP switches for system configuration

options. The DIP switches can be used to modify certain system operating condi-

tions. Review the Factory Default Settings Section to determine if it is necessary to

change the DIP switches from the factory default positions. For reference, the fac-

tory default settings are:

DIP Switch S1001 All OFF

DIP Switch S1002 Switch 5 ON, 7 ON, and 8 ON; All others OFF

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 103 104

Pas de commentaire

Bosch LTC 8500 Manuel d'instructions Page 27