Bosch LTC 8500 Manuel d'instructions télécharger pdf (Page 61)

Sequence Programming

EN | 51

Continue entering camera, monitor, and dwell times in this fashion until finished. If

you only want to store the sequence for future use and then exit the programming

mode, press Exit / Save [Prog]. Press Exit / Run [Run], to exit the programming

mode, store the sequence into memory, and start the sequence running. The

switcher steps through the five (5) steps in the order shown, and repeats the

sequence when it reaches the last step.

To p r o g r a m a s e q u e n c e to run once through all its steps and then stop, enter the

value 62 for the dwell time in the last step and press [Enter]. The dwell display will

change to STP, meaning stop. To program a sequence to run once through all its

steps and then unload itself, enter the value 63 for the dwell time in the last step, and

press [Enter]. The dwell display will change to ULD, meaning unload.

To e d i t an existing sequence, press Program Sequence [Prog], enter the existing

sequence number, then press [Enter]. You can insert a line into a sequence by navi-

gating down to the line where inserting a new line, and press Insert Step [ON]. A

new line identical to the one you are on is added to the next step. To delete a step,

navigate to the line to be deleted, and press Delete Current Step [OFF]. To delete all

steps below the line you are viewing, press Delete From Here To End [Lock]. (Be

careful with this feature!)

It is also possible to erase a sequence: Press Delete From Here To End [Lock] while

on the first line of the sequence. Then press Delete Current Step [OFF]. The

sequence will be erased, and the programming mode is automatically exited.

Sequence Function Summary

All programming key functions for the LTC 8555 Series are summarized in the fol-

lowing table:

Key Description

PROG Selects or terminates program mode

CLEAR Clears current entry

ENTER Stores current entry

PREV Stores entry and move up one step

NEXT Stores entry and move down one step; add new

step if necessary

ON Insert step before current step

OFF Delete current step

UP Move up one step

DOWN Move down one step, if step already exists

LEFT Move prompt left one cell

RIGHT Move prompt right one cell

LOCK Erase all steps after current step

RUN Exit, store, load, and run current sequence

1 2 ... 56 57 58 59 60 61 62 63 64 65 66 ... 103 104

Pas de commentaire

Bosch LTC 8500 Manuel d'instructions Page 61