Bosch 11 KW Manuel d'instructions télécharger pdf (Page 35)

CONTROL PANEL

6 720 806 768 (2013/02) 35

15 CONTROL PANEL

Settings for the control of the heat pump are made with the control unit's

control panel, which also provides information about current status.

15.1 PANEL OVERVIEW

Fig. 42 The control panel

[1] On/Off button

[2] Mode button

[3] Info button

[4] Menu dial

[5] Status lamp

[6] Return button

[7] Menu button

[8] Menu display

15.2 ON/OFF BUTTON

Use the On/Off button to turn the heat pump on and off.

15.3 STATUS LAMP

15.4 MENU DISPLAY

Use the menu display in order to:

• View information from the heat pump.

• View available menus.

• Change set values.

15.5 MENU BUTTON AND MENU DIAL

Use to get from the Initial menu to the menus. Use the menu dial in

order to:

• Navigate the menus and get to the setting displays.

– Turn the dial to see more menus on the same level or change a set

value.

– Press the dial to change to a lower menu level or save a change.

15.6 RETURN BUTTON

Use to:

• Go back to the previous menu level.

• Leave a setting display without changing the set value.

15.7 MODE BUTTON

Use to change type of operation.

• Change type of operation.

15.8 INFO BUTTON

Use to see information from the control unit about operating

mode, temperature, program version, etc.

16 START UP

The first time the heat pump is started, a number of settings are

displayed automatically so as to facilitate putting it in operation.

Before this stage, the heat pump should be installed in accordance with

the previous sections ( Chapter 13,

 Chapter 14). Collector circuits, heating circuits and hot water

circuits should be filled and vented.

The settings are also available under ordinary installer menus.

LANGUAGE, COUNTRY, OPERATING MODE AND ELECTRICAL

CONNECTION

▶ Select language for the menus of the control unit

( Chapter 20.10).

▶Select Country ( Chapter 20.10).

▶ Select operating mode (L/W + electric additional heat)

( Chapter 8.4,  Chapter 20.7).

▶Select Electrical connection (230V).

START-UP

Review and adjust, as required, the functions below. See the references

for description of the functions.

The lamp lights continuously. The heat pump is running.

The lamp flashes rapidly. There is an alarm that has not been

acknowledged.

The alarm has been acknowledged

but the alarm cause remains.

The lamp flashes slowly, menu

window not lit.

The heat pump is in stand-by mode

1) Stand-by means that the heat pump is running but no heating or hot water

demand exists.

The lamp and menu display not

lit.

No voltage to the control unit.

Table 20 Lamp functions

The controller language can be changed with the

button.

▶ Press the button in the initial menu for at least 5

s, then select the required language.

Only functions which are identified by the control unit

are displayed in the initial menu.

The start-up menus are available until Yes is entered in

Start-up completed.

▶ Read the complete menus before start-up.

▶ A selection must be made in Heat pump x capacity

and Protective anode installed.

With the -button, return to the previous menu

once settings have been made.

The selected system solution would normally require a

review of more settings than the ones in the start-up.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 71 72

Commentaires sur ces manuels

Pas de commentaire

Bosch 11 KW Manuel d'instructions Page 35

Commentaires sur ces manuels

Produits connexes et manuels pour Pompes à chaleur Bosch 11 KW