Bosch PIN8 N1 Guide de dépannage télécharger pdf (Page 406)

100

101

7-100 Operating Modes MPH-02, MPB-02, MPD-02

DOK-INDRV*-MP*-02VRS**-FK01-EN-P

The following variants are available to do this:

• P-0-0155 bit 5 = 0

→ velocity adjustment only carried out once, all following changes of

velocity are carried out with maximum acceleration

• P-0-0155 bit 5 = 1

→ each change of velocity is limited by the value of P-0-0142,

Synchronization acceleration

See also Parameter Description "P-0-0155, Synchronization

mode"

electronic

gear

with

fine adjust

master axis

evaluation

and

adjustment

internal

cmd

value

dynam.

synchron-

ization

cmd value processing

specific to oper. mode

P-0-0777

adjustment of

velocity format

DF000121v01_en.fh7

P-0-0159

S-0-0044

Fig. 7-78: Command value processing and command value adjustment specific

to velocity synchronization

Notes on Commissioning/Parameterization

For general parameterization it is necessary to make machine-specific

presettings:

• scaling of parameter data (linear or rotary)

• S-0-0076, S-0-0077, S-0-0078 and S-0-0079 for position data

• S-0-0044, S-0-0045 and S-0-0046 for velocity data

• S-0-0160, S-0-0161 and S-0-0162 for acceleration data

See "Mechanical Axis System and Measuring Systems: Scaling of

Physical Data" in chapter "Motor, Mechanical Axis System, Measuring

Systems"

• for linear scaling with rotary motor, parameterizing the feed constant

per slave axis revolution (S-0-0123)

• parameterizing the load gear of the slave axis (S-0-0121 and

S-0-0122)

General Parameterization

1 2 ... 401 402 403 404 405 406 407 408 409 410 411 ... 727 728

Commentaires sur ces manuels

Pas de commentaire

Bosch PIN8 N1 Guide de dépannage Page 406

Commentaires sur ces manuels

Produits connexes et manuels pour Plaques chauffantes Bosch PIN8 N1