Bosch PIN8 N1 Guide de dépannage télécharger pdf (Page 128)

100

101

5-4 Motor, Mechanical Axis System, Measuring Systems MPH-02, MPB-02, MPD-02

DOK-INDRV*-MP*-02VRS**-FK01-EN-P

Note: In the case of MHD, MKD, LSF, MBS and MKE motors, the

motor temperature, due to the sensor characteristics, can only

be determined very inexactly. Shutdown is caused by abrupt

resistance increase of the sensor at maximum temperature!

The warning and shutdown thresholds (S-0-0201 and

S-0-0204) to be set cannot be used!

Third-party motors may include temperature sensors that do not

correspond to the standard type sensors. This information is given to the

controller via the P-0-0512, Temperature sensor parameter. The

respective resistance temperature characteristic then has to be input

manually as a table of values in the P-0-0513, Temperature sensor

characteristic parameter.

Third-party motors without installed temperature sensor can also be

operated with IndraDrive controllers, but in the case of overload they are

not protected on the controller side against thermal damage! The

temperature monitor has to be switched off in the mentioned case,

because otherwise the controller demands a temperature sensor to be

connected.

See also "Third-Party Motors at IndraDrive Controllers" in the same

chapter

Notes on Commissioning

For the following parameters it is necessary to replace the default value

by an adjusted value during commissioning.

Rexroth motors with the characteristic temperature sensor number "1"

(MHD, MKD, LSF, MBS motors) or "4" (MKE motors):

→ No temperature sensor relevant parameter setting required!

Rexroth motors with the characteristic temperature sensor number "2",

"3" or "5" (2AD, ADF, 1MB, MAD, MAF or SF motors):

• S-0-0201, Motor warning temperature

Third-party motors with the characteristic temperature sensor number "2",

"3" or "5":

• P-0-0512, Temperature sensor

• S-0-0201, Motor warning temperature

• S-0-0204, Motor shutdown temperature

Third-party motors with the characteristic temperature sensor number

"100":

• P-0-0512, Temperature sensor

• P-0-0513, Temperature sensor characteristic

• S-0-0201, Motor warning temperature

• S-0-0204, Motor shutdown temperature

Note: The value in parameter S-0-0201 has to be smaller than the

value of S-0-0204!

It is not necessary to separately activate the temperature monitor of the

motor. You only have to enter the appropriate values in the respective

parameters.

Third-Party Motors

Relevant Parameters

Activating the Function

1 2 ... 123 124 125 126 127 128 129 130 131 132 133 ... 727 728

Commentaires sur ces manuels

Pas de commentaire

Bosch PIN8 N1 Guide de dépannage Page 128

Commentaires sur ces manuels

Produits connexes et manuels pour Plaques chauffantes Bosch PIN8 N1