Bosch 1710 Manuel d'utilisateur télécharger pdf (Page 48)

48 en | Configuration using a Web browser VideoJet XTC XF

DOC | V5.60 | 2012.09 Installation and Operating Manual Bosch Sicherheitssysteme GmbH

5.19 Network > Advanced

The settings on this page are used to implement advanced settings for the network.

Some changes only take effect after the unit is rebooted. In this case, the Set button changes

to Set and Reboot.

1. Make the desired changes.

2. Click the Set and Reboot button. The unit is rebooted and the changed settings are

activated.

SNMP

The VideoJet XTC XF transcoder supports the SNMP V2 (Simple Network Management

Protocol) for managing and monitoring network components, and can send SNMP messages

(traps) to IP addresses. The unit supports SNMP MIB II in the unified code. If you wish to send

SNMP traps, enter the IP addresses of one or two required target devices here.

If you select On for the SNMP parameter and do not enter an SNMP host address, the unit

does not send the SNMP traps automatically, but only replies to SNMP requests. If you enter

one or two SNMP host addresses, SNMP traps are sent automatically. Select Off to deactivate

the SNMP function.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 79 80

Pas de commentaire

Bosch 1710 Manuel d'utilisateur Page 48