Bosch 1710 Manuel d'utilisateur télécharger pdf (Page 41)

VideoJet XTC XF Configuration using a Web browser | en 41

Bosch Sicherheitssysteme GmbH Installation and Operating Manual DOC | V5.60 | 2012.09

5.15 Interfaces > Alarm Inputs

You can configure the alarm inputs of the VideoJet XTC XF transcoder.

Alarm input

Select N.O. if the alarm is to be triggered when the contact closes. Select N.C. if the alarm is

to be triggered when the contact opens.

Name

You can enter a name for each alarm input. If the LIVEPAGE functions are configured

accordingly, this name is displayed below the icon for the alarm input. You can also use the

name in the Forensic Search program function as a filter option for quick search in recordings.

Enter a unique and clear name here.

Further topics:

– Section 5.7 Web Interface > LIVEPAGE Functions, page 29

5.16 Interfaces > Relay

You can configure the switching behavior of the relay output. You can specify an open switch

relay (normally closed contact) or a closed switch relay (normally open contact).

You can also specify whether the output should operate as a bistable or monostable relay. In

bistable mode, the triggered state of the relay is maintained. In monostable mode, you can set

the time after which the relay will return to the idle state.

CAUTION!

Do not use any special characters, for example &, in the name.

Special characters are not supported by the system's internal management.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 79 80

Pas de commentaire

Bosch 1710 Manuel d'utilisateur Page 41