Bosch 1710 Manuel d'utilisateur télécharger pdf (Page 49)

VideoJet XTC XF Configuration using a Web browser | en 49

Bosch Sicherheitssysteme GmbH Installation and Operating Manual DOC | V5.60 | 2012.09

1. SNMP host address / 2. SNMP host address

If you wish to send SNMP traps automatically, enter the IP addresses of one or two required

target units here.

SNMP traps

You can select which traps are to be sent.

1. Click Select. A list is opened.

2. Click the checkboxes to select the required traps. All the checked traps will be sent.

3. Click Set to accept the selection.

Authentication

If a RADIUS server is employed in the network for managing access rights, authentication

must be activated here to allow communication with the unit. The RADIUS server must also

contain the corresponding data.

To configure the unit, you must connect the transcoder directly to a computer. This is because

communication via the network is not enabled until the Identity and Password parameters

have been set and successfully authenticated.

Identity

Enter the name that the RADIUS server is to use for identifying the unit.

Password

Enter the password that is stored in the RADIUS server.

RTSP port

If necessary, select a different port for the exchange of the RTSP data from the list. The

standard RTSP port is 554. Select Off to deactivate the RTSP function.

UPnP

You can activate the Universal Plug and Play (UPnP) function. If the function is turned on, the

unit responds to requests from the network and is automatically registered on the requesting

computers as a new network device. For example, access to the unit can then be made using

Windows Explorer without knowledge of the IP address of the unit.

This function should not be used in large installations because of the variety of potential

registration notifications.

Video / Control

The quality of service of the different data channels can be set by defining the DiffServ Code

Point (DSCP). Enter a number between 0 and 252 as a multiple of four.

NOTICE!

To use the UPnP function on a computer, both the Universal Plug and Play Device Host and

SSDP Discovery Service must be active in Windows XP and Windows 7.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 79 80

Pas de commentaire

Bosch 1710 Manuel d'utilisateur Page 49