Bosch 1710 Manuel d'utilisateur télécharger pdf (Page 45)

VideoJet XTC XF Configuration using a Web browser | en 45

Bosch Sicherheitssysteme GmbH Installation and Operating Manual DOC | V5.60 | 2012.09

The settings on this page are used to integrate the VideoJet XTC XF transcoder into an

existing network.

Some changes only take effect after the unit is rebooted. In this case, the Set button changes

to Set and Reboot.

1. Make the desired changes.

2. Click the Set and Reboot button. The unit is rebooted and the changed settings are

activated.

Automatic IP assignment

If a DHCP server is employed in the network for the dynamic assignment of IP addresses, you

can activate acceptance of IP addresses automatically assigned to the transcoder.

Certain applications (Bosch Video Client, Bosch Video Management System) use the IP

address for the unique assignment of the unit. If you use these applications, the DHCP server

must support the fixed assignment between IP address and MAC address, and must be

appropriately set up so that, once an IP address is assigned, it is retained each time the

system is rebooted.

IPv4

For IPv4 connections, fill-in the required information:

1. Enter the desired IP address for the VideoJet XTC XF transcoder in the IP address field.

The IP address must be valid for the network.

2. Enter the appropriate subnet mask for the selected IP address.

3. If you want the unit to establish a connection to a remote location in a different subnet,

enter the IP address of the gateway in the Gateway address field. Otherwise leave the

box blank (0.0.0.0).

If necessary, you may also enter the parameters for IPv6 connections.

IPv6

For IPv6 connections, fill-in the required information:

1. Enter the desired IP address for the VideoJet XTC XF transcoder in the IP address field.

The IP address must be valid for the network.

2. Enter the appropriate prefix length for the set IP address.

3. If you want the unit to establish a connection to a remote location in a different subnet,

enter the IP address of the gateway in the Gateway address field. Otherwise leave the

box blank (0.0.0.0).

If necessary, you may also enter the parameters for IPv4 connections.

DNS server address

The unit can use a DNS server to resolve a mail or FTP server address specified as a name.

Enter the IP address of the DNS server here.

Video transmission

If the unit is operated behind a firewall, TCP (HTTP port) should be selected as the transfer

protocol. For use in a local network, select UDP.

TCP rate control

Activate this option If you want to allow Adaptive Bit Rate encoding.

CAUTION!

If you change the IP address, subnet mask, gateway address or the DHCP setting, the unit is

only available under the new addresses after the reboot.

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 79 80

Commentaires sur ces manuels

Pas de commentaire

Bosch 1710 Manuel d'utilisateur Page 45

Commentaires sur ces manuels