Bosch 1710 Manuel d'utilisateur télécharger pdf (Page 42)

42 en | Configuration using a Web browser VideoJet XTC XF

DOC | V5.60 | 2012.09 Installation and Operating Manual Bosch Sicherheitssysteme GmbH

You can select different events that automatically activate an output. It is possible, for

example, to turn on a floodlight by triggering a motion alarm and then turning the light off

again when the alarm has stopped.

Idle state

Select Open if you want the relay to operate as an NO contact, or select Closed if the relay is

to operate as an NC contact.

Operating mode

Select an operating mode for the relay.

For example, if you want an alarm-activated lamp to stay on after the alarm ends, select

Bistable. If you wish an alarm-activated siren to sound only for a defined period, for example,

select the corresponding setting.

Relay follows

Select the event that triggers the relay.

Relay name

You can assign a name for the relay here. The name is shown on the button next to Trigger

relay. If the LIVEPAGE functions are configured accordingly, this name is displayed below the

relay icon. You can also use the name in the Forensic Search program function as a filter

option for quick search in recordings. Enter a unique and clear name here.

Further topics:

– Section 5.7 Web Interface > LIVEPAGE Functions, page 29

Trigger relay

Click the button to trigger the relay manually (for testing or to operate a door opener, for

example).

5.17 Interfaces > COM1

You can configure the serial interface parameters (orange terminal block) to meet your

requirements.

CAUTION!

Do not use any special characters, for example &, in the name.

Special characters are not supported by the system's internal management.

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 79 80

Pas de commentaire

Bosch 1710 Manuel d'utilisateur Page 42