Bosch 7000 Series Manuel télécharger pdf (Page 28)

 Bosch Alarm Panel Interface Manual

Revision 1.4

8.3.5 How to see and manage the IP connections between services

The TCP/IP Connections tab shows the incoming and outgoing IP connections between GCS Services.

The ClientGW Service and the DBWriter Service should each show a connection in this screen. There

should only be one Client Gateway connection even if the system has more than one client.

FIG 12: Alarm Panel Service screen/Connecting to the DBWriter (cropped)

Right-click the panel status and

Select the desired command

User can manually connect and disconnect from the services by right-clicking the TCP/IP Service

Connections screen and getting a shortcut menu.

` Force Disconnect option: allows operator to manually disconnect the selected service.

ª The incoming (ClientGW) service should reconnect automatically within 30 to 60 seconds

provided it is up and running.

ª The outgoing connection to DB Writer Service can be forced to reconnect using the ‘Connect

to Server’ option on the shortcut menu.

` Connect To Server option: allows the user to manually connect to the downstream service (in this

case the DBWriter). To reconnect manually, you must know the IP address and port number of the

downstream service. DBWriter listens on port 4001. Use the NIC card loop-back address (127.0.0.1)

if the DBWriter and Alarm Panel service are both running on the same computer (which should be

the case).

4001

Page 28 of 37

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 36 37

Pas de commentaire

Bosch 7000 Series Manuel Page 28