Bosch 7000 Series Manuel télécharger pdf (Page 13)

 Bosch Alarm Panel Interface Manual

Revision 1.4

5 Add an Alarm Panel in System Galaxy

The alarm panel must be added in the System Galaxy software before the GCS Alarm Panel Service will

connect to the panel. The programming must match the Alarm Panel configuration.

After Panel, Areas and Points are added, System Galaxy can begin receiving status events from the

alarm panel. The alarm panel events are displayed in the Alarm Panel Event screen.

STEP 5: Add an Alarm Panel as follows: (SG main menu: Configure>Hardware>Alarms)

Part 1: open the Alarm Panel Property screen (Configure>Hardware>Alarms>Alarm Panels)

Part 2: click the Add button and set the following fields as needed:

 Name field: type a descriptive name

 ID number: (the system assigns the system ID)

 Panel Type: pick ‘BOSCH D9000/D7000 Series from the droplist

 Connection Method: choose appropriate connection type (also see Step 1 of Section 2.1 )

a) On Board Ethernet: if connecting to the Bosch DX4020 Ethernet module

b) Serial Comm. Port: if connecting to the Bosch DX4010i module

c) Lantronix with TCP/IP: if connecting to the panel via Lantronix device

 IP Address: enter the IP Address depending on the Connection Method chosen:

a) IP Address of the DX4020 Ethernet module if On-board Ethernet option is chosen

b) (not used) if Serial Com Port option for 4010i is chosen

c) IP Address of the Lantronix device if using Lantronix with TCP/IP option is chosen

 Port Number: enter the port number if an IP Address is used:

a) 3001 (Lantronix)

b) blank if direct connect (serial com port connection to 4010i)

c) 7700 (Ethernet 4020 Module)

 Com Port (if using Serial Comm. Port): pick the com port being used at the PC

 Baud Rate(if using Serial Comm. Port): set to 9600

 Passcode: blank/not used

 Communication Server: Enter Name of PC that will run the GCS Alarm Panel Service.

Part 3: click the Apply button to save the settings.

FIG 5a: Alarm Panel Property screen (cropped)

Page 13 of 37

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 36 37

Pas de commentaire

Bosch 7000 Series Manuel Page 13