Bosch DS7445 Guide de l'utilisateur télécharger pdf (Page 35)

- 35 -

Testing your System (continued)

This chart explains the procedure for performing a Fire Walk Test.

This test is used to confirm that Smoke detectors will report alarms to the keypads.

The Fire Walk Test tests all fire zones, including verified fire and waterflow.

At the start of the Fire Walk Test a Fire Walk Test report, if programmed, is sent to the central station.

Fire alarm reports are not sent to the central station during the Fire Walk Test.

A Fire Walk Test restoral is sent upon completion of the Fire Walk Test.

The Fire Walk Test is enabled for 20 minutes once it is started.

The test time is extended to 20 minutes every time another zone is tested.

When a fire zone is tested, any output programmed to follow that zone will activate for 5 seconds.

A Fire Walk Test will prevent the system from sending any Fire Reports during the test.

DS7447:

“Fire Test”

will displa

followed b

the

zone number of an

zones that have not been tested.

DS7445: The Zone LEDs will flash for an

zones that

have not been tested.**

DS7447:

“Fire Testin

”

will be displa

ed followed

the zone number of the zone that is currentl

bein

violated (bein

tested). It returns to

“Fire Test”

after

the violation.

DS7445: The Zone LED will turn on stead

for the

zone that is currentl

bein

violated (tested).

Test each detector one at a

time as instructed b

the

installin

compan

To exit the Fire WalkTest

enter

our [PIN] + the [#] ke

Fire

Walk

Test

pe of

Test

What will Happen

Command

Sequence

What to Do

PIN + [#] [9] [1]

Zones 1-8 onl

will be displa

ed on a DS7445 ke

pad.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 47 48

Commentaires sur ces manuels

Pas de commentaire

Bosch DS7445 Guide de l'utilisateur Page 35

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Bosch DS7445