
- 10 -
This chart explains the procedure for Force Arming your
system if one or more zones are faulted.
When one or more zones are faulted, the system may be Force
Armed (if programmed) by bypassing the faulted zones. The
DS7447 display will read “Not Ready” and the DS7445's zone
LEDs (1-8) will be on when Force Arming is required to arm the
system.
Force Arming during an AC power failure: Regular arming
of the control panel is not permitted during an AC power failure.
Having to Force Arm serves as a warning that the control panel
is operating under backup battery.
WARNING
Bypassing or Force Arming removes some of your building’s
protection because it excludes the faulted zones from arming.
Therefore, an intrusion may not be detected or the detection
may be delayed. Always attempt to correct any zone problems
(close doors and windows, etc.) before using these features. If
the problem can not be corrected, contact your installing
company.
Note: See
Zone Bypass
for an alternate method of arming
the system when faults exist. Force arming is not
available in U.L. Listed systems.
Force Arming your System
What to DoT
pe of Armin
What to Do What will HappenWhat will Happen
Force
Armin
Enter an
armin
command
Press
[B
pass]
durin
the 5
second beep.
Exit durin
the
exit dela
interval if
leavin
.
A five second beep occurs,
indicatin
the control panel
has faulted zones and needs
to be Force Armed, or a
three-beep error tone occurs
indicatin
Force Armin
has
not been accepted or allowed.
The red Armed Li
ht will flash
durin
the exit dela
.
The control panel will arm with the
faulted zones b
passed, or a
three-beep error tone occurs
indicatin
Force Armin
has not
been accepted or allowed.
Commentaires sur ces manuels