Bosch APC-AMC2-4WCF Manuel d'installation télécharger pdf (Page 37)

AMC2 4W | Installation manual Installing | en 37

Bosch Sicherheitssysteme GmbH F.01U.024.965 | V 0.1 | 2006.03

5.6.3 DIL Switch Address Selector

The first four DIL switches for address selection define the RS-

485 address of the AMC2 4W in a RS-485 bus system. Switch 5

selects on of the two different protocols, SDEB and BPA

(according to DIN6619). Switch 6 sets the connection to the

host system to either RS-232 or RS-485.

Fig. 5.13 Location of the RS-485 address selector

NOTE!

Using Ethernet connection it is recommended to set switch 1 to

ON (= delivery status)

Using RS-232 connection the address must be set, which is con-

figured in the Device Editor. Therefore this is a point-to-point

connection the usually configured address will be 1 - so the

switch 1 must be also set to ON.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 61 62

Pas de commentaire

Bosch APC-AMC2-4WCF Manuel d'installation Page 37