Bosch VIP X1600 Module Manuel d'utilisateur télécharger pdf (Page 14)

14 en | Installation VIP X1600 XFM4

DOC | V4.2 | 2010.07 Installation and Operating Manual Bosch Security Systems

4 Installation

4.1 Preparations

The module is exclusively designed for installation in the VIP X1600 XF base system. Installing

the units is a quick and easy operation that does not require any additional tools.

4.2 Installing Modules

Installation of the different VIP X1600 XF modules in the VIP X1600 XF base system is

described in the relevant Quick Installation Guide. Please also take note of the following basic

notes when installing a unit.

Installation Sequence and Capacity of the VIP X1600 XF Base System

You can install up to four modules in a VIP X1600 XF base system. Slot 1 must always be the

first slot that is populated. The remaining slots can be populated in any order desired. It is

also possible to install and remove modules during operation.

Cooling

The installed modules generate a high volume of heat during operation. As a result, it is

essential that a functional heat dissipation system is in place for problem-free operation of a

VIP X1600 XF.

Rating Plates

Every module has a label on the circuit board containing a printed MAC address by which the

module can be uniquely identified. Take note of this MAC address and the location in the

VIP X1600 XF base system before installation so that you can later identify the module, even

after it has been inserted (for example when performing fault diagnosis).

CAUTION!

Do not install a module in a different housing and do not operate the module outside of the

VIP X1600 XF base system. The ambient temperature during installation must be between

0 and +40 °C (+32 and +104 °F), and the relative humidity must not exceed 95% (non-

condensing).

CAUTION!

Ensure that Slot 1 is always populated by a module, even when modifying the installation.

Malfunctions may occur when the VIP X1600 XF base system is switched on without a

functional module in Slot 1.

CAUTION!

Whenever the installation is modified, or modules are exchanged or supplemented, it is

essential that all unpopulated slots are properly covered on the rear panel of the VIP X1600 XF

base system.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 121 122

Pas de commentaire

Bosch VIP X1600 Module Manuel d'utilisateur Page 14