Bosch DIP-6082-8HD Manuel d'installation télécharger pdf (Page 16)

Notice!

We recommend using the respective Bosch hard disk drives. The hard disk drives as one of

the critical component are carefully selected by Bosch based on available failure rates. HDD –

not delivered from Bosch – are not supported. Information on supported HDDs can be found

in the datasheet in the Bosch Online Product Catalog.

Installing an optional floppy or fixed hard drive

The chassis models include two open slots for an optional floppy drive, and/or hard disk

drive(s). To utilize these slots, the dummy drive and the slot cover must be removed.

To remove the dummy drive or hard disk drive:

1. Disconnect the chassis from any power source.

2. Press the release tab.

3. Push against the back of the dummy drive, sliding the dummy drive and slot cover

forward, out through the front of the chassis.

4. Insert the drive into rear of the open slot and connect the wiring.

3.3

16 en | Chassis setup and maintenance DIVAR IP 6000 2U

2014.01 | V2 | DOC Installation Manual Bosch Sicherheitssysteme GmbH

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 53 54

Pas de commentaire

Bosch DIP-6082-8HD Manuel d'installation Page 16