Installing a hard drive
The drives are mounted in drive carriers.
To install a hard drive to the hard drive carrier:
1. Remove the screws securing the dummy drive to the carrier.
2. Remove the dummy drive from the carrier.
3. Install a new drive into the carrier with the printed circuit board side facing down so that
the mounting holes align with those in the carrier.
4. Secure the hard drive by tightening all 6 screws.
1
Drive carrier 2 SAS/SATA hard drive
5. Replace the drive carrier into the chassis bay. Make sure that the drive carrier handle is
completely closed.
3.2.2
DIVAR IP 6000 2U Chassis setup and maintenance | en 15
Bosch Sicherheitssysteme GmbH Installation Manual 2014.01 | V2 | DOC
Commentaires sur ces manuels