Bosch D9112B Guide de l'utilisateur télécharger pdf (Page 41)

PERIMETR PART ?

Partially Turn On the Perimeter

Description

This function is used to turn on the perimeter of your building

while selected portions of the perimeter remain turned off.

Perimeter points that are not secure (faulted) when this function

is entered are automatically bypassed and are not included in the

system. This function does not turn on the interior of your

building. Entry/exit delays are provided with this arming

command.

Use this function in residential systems to turn on the front of

your house while the interior and the rear perimeter doors are

left turned off, giving you freedom of movement between the

house and patio.

In commercial systems, when you need access to the large

overhead doors to receive deliveries, using this function will allow

you to keep the rest of the building perimeter armed.

Using Perimetr Part:

1. Ensure that the command center shows disarmed idle

text. Before using this function, decide which points are

to be left turned off. Fault the points (doors and windows)

by leaving them open. The points must remain open until

after the exit delay time expires.

2. Press the COMMAND bar. The display shows SYSTEM

COMMAND.

3. Press the 8 key.

Note: If you prefer, you may use the Command Menu in place

of steps 2 and 3 to initiate this function. Press the MENU

key to enter the Command Menu, then press NEXT

repeatedly until you reach the PERIMETR PART ?

prompt. Press ENT.

4. The display shows EXIT NOW #. When exit delay time

expires and the system turns on, the display shortens to

PERIMETR PARTIAL.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 55 56

Pas de commentaire

Bosch D9112B Guide de l'utilisateur Page 41