Bosch D720 Guide d'installation télécharger pdf (Page 64)

D9412GV3/D7412GV3 | Operation and Installation Guide | 13.0 Programmer and Accessory Connections

64 Bosch Security Systems, Inc. | 2/10 | F01U143070-01

If supervised and the module does not respond to

control panel supervision polls, SERVC SDI 88

appears at the keypad. The report to the receiver

includes the address of the troubled module indicating

which module needs service.

13.0 Programmer and

Accessory Connections

13.1 Programmer Connector

Refer to the D5200 Operation Manual

(P/N: 74-06176-000) for complete information on

using the D5200 programmer.

To connect and disconnect the programmer:

1. Lock the Reset Pin (Figure 30).

2. Connect the D5200 Data/Power cord to the

programming connector on the control panel

(Figure 31).

3. Perform the desired programming function (send

or receive program).

4. Disconnect the programmer.

Figure 30: Reset Pin

Reset Pin

Disable all except Battery

Charg ing and Programming

PERIPHER AL DEVICE CONNECTIO NS

RED PO WER +

YELLOW

D ATA BUS A

GR EEN D AT A BUS B

BLACK C OM MO N

1 - Reset Pin locked (closed)

2 - Reset Pin normal (open) for normal control

panel operation

13.2 Programmer Access Reports

When a program is sent to the control panel, the

control panel sends a Prog Access OK report 10 sec

after the handler exits or when the programmer

disconnects. The prompt in routing must be

programmed Yes to send this report.

13.3 Accessory Connector

Use the accessory connector to connect the control

panel to the D928 Dual Phone Line Switcher. The

accessory connector is on the bottom right corner of

the I/O board (Figure 31). The D928 lets the control

panel use two telephone lines to send reports.

Refer to Section 7.11 D928 Dual Phone Line Switcher

on page 32 for installation and operating instructions.

Figure 31: Programmer and Accessory

Connections

21 22

Reset Pin

Disable all except Battery

Charging and Programming

PERIPHERAL DEVICE CON NECTIONS

RED POWER +

YELLO W DATA BUS A

GREEN DATA BUS B

BLACK COMMON

ZO NE X OU T 1

ZONEX IN 1

N.F.P.A.

Style 4.0

Signaling

Line

Circuits

ZO NEX POWER +

ZO NEX COMMO N

ZO NEX OUT 2

ZO NEX IN 2

Operat io n M onit or LE D

Pu lse s whe n No rmal

Flick er s wh en Rin ging

GREEN

D5 200/D5 360

PROG CONN

Poi nt 8, S3 Option

Clos ed = 1 k

EOL

N or m al Ope r ati on

Op en =AB-1 2 UL

Bel l Box 2 20 k

2525

1 - Accessory connector

2 - Programming connector

1 2 ... 59 60 61 62 63 64 65 66 67 68 69 ... 75 76

Commentaires sur ces manuels

Pas de commentaire

Bosch D720 Guide d'installation Page 64

Commentaires sur ces manuels

Produits connexes et manuels pour Claviers numériques Bosch D720