Bosch WAT28460GB Manuel d'instructions télécharger pdf (Page 34)

en Positioning and connecting

34

Before washing for the first

time

The washing machine was thoroughly

tested before leaving the factory. To

remove any water that may be left over

from the test, run the first wash cycle

without any laundry.

Notes

■ The washing machine must be

correctly installed and connected.

(from ~ Page 27).

■ Never use a damaged machine.

Inform customer services.

1. Check the machine.

2. Remove the protective film from the

control panel.

3. Connect the mains plug.

4. Turn on the tap.

5. Close the door (do not load any

laundry).

6. Depending on the model, run the ¾

Drum Clean 90 °C or i

Cottons 90 °C program.

7. Open the detergent drawer.

8. Pour approximately 1 litre of water

into compartment II.

9. Pour standard detergent into

compartment II.

Note: To prevent foaming, only use

half the amount of detergent

recommended by the detergent

manufacturer. Do not use detergent

designed for wool or delicates.

10.Close the detergent drawer.

11.Press the A button.

12.When the program ends, switch off

the appliance.

Your washing machine is now ready to

use.

Transportation

e.g. when moving home

Preparatory work:

1. Turn off the water tap.

2. Reduce the water pressure in the

supply hose.

Maintenance – filter in the water

supply ~ Page 22

3. Drain the remaining detergent

solution.

Maintenance – detergent solution

pump blocked ~ Page 21

4. Disconnect the washing machine

from the mains.

5. Remove the hoses.

Installing the transport locks:

1. Remove the covers and keep them

in a safe place.

Use a screwdriver if necessary.

2. Insert all four sleeves.

Clip the mains cable securely in the

holders. Insert and tighten the

screws.

Before switching on the appliance

again:

Notes

■ The transport braces must be

removed.

1 2 ... 29 30 31 32 33 34 35 36

Commentaires sur ces manuels

Pas de commentaire