Bosch WAT28460GB Manuel d'instructions télécharger pdf (Page 22)

en Cleaning and maintenance

22

4. Take the drain hose out of the

retainer.

Remove the sealing cap, allow the

detergent solution to flow out into a

suitable container.

Replace the sealing cap and place

the drainage hose in the retainer.

5. Carefully unscrew the pump cover,

residual water may leak out.

Clean the interior, pump cover

thread and pump housing. The

impeller in the detergent solution

pump must be able to rotate.

Refit the pump cover and screw it on

tightly. The handle must be in a

vertical position.

6. Place the service flap back on, lock

it into place, and close it.

Note: To prevent unused detergent

from flowing straight into the drain

during the next wash: Pour 1 litre of

water into compartment II and start the

[ Empty programme.

The drain hose at the siphon

is blocked

1. Switch off the appliance. Disconnect

the mains plug.

2. Loosen the hose clamp. Carefully

remove the drain hose, residual

water may leak out.

3. Clean the drainage hose and siphon

connecting piece.

4. Reattach the drainage hose and

secure the connection using the

hose clamp.

Filter in the water supply

blocked

First, reduce the water pressure in the

supply hose:

1. Turn off the tap.

2. Select any program (except Rinse//

Spin/Empty).

3. Press the A button.Allow the

program to run for approximately 40

seconds.

4. Turn the program selector to Off.

Pull out the mains plug.

5. Clean the filter on the tap:

Disconnect the hose from the tap.

Clean the filter with a small brush.

6. For standard and Aqua-Secure

models, clean the filter on the rear of

the appliance:

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 35 36

Commentaires sur ces manuels

Pas de commentaire