Bosch FW5.50 Manuel d'utilisateur télécharger pdf (Page 31)

Camera Browser Interface Advanced General Settings | en 31

Bosch Security Systems Software manual AM18-Q0611 | v5.50 | 2012.03

First, check the time zone setting. If it is not correct, select the

appropriate time zone for the system:

1. Click Set.

2. Click Details. A new window opens showing an empty

table.

3. Click Generate to fill the table with the preset values from

the camera.

4. Select the region or the city which is closest to the

system's location from the list box below the table.

5. Click one of the entries in the table to make changes. The

entry is highlighted.

6. Click Delete to remove the entry from the table.

7. Choose other values from the list boxes under the table, to

change the selected entry. Changes are immediate.

8. If there are empty lines at the bottom of the table, for

example after deletions, add new data by marking the row

and selecting values from the list boxes.

9. When finished, click OK to save and activate the table.

6.3.5 Time server IP address

The camera can receive the time signal from a time server using

various time server protocols and then use it to set the internal

clock. The device polls the time signal automatically once every

minute.

Enter the IP address of a time server.

6.3.6 Time server type

Select the protocol that is supported by the selected time

server. It is recommended to select the SNTP server protocol.

This protocol provides high accuracy and is required for special

applications and future function extensions.

Select Time server if the server uses the RFC 868 protocol.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 93 94

Pas de commentaire

Bosch FW5.50 Manuel d'utilisateur Page 31