Bosch FW5.50 Manuel d'utilisateur Page 26
- Page / 94
- Table des matières
- MARQUE LIVRES
Noté. / 5. Basé sur avis des utilisateurs
26 en | Basic Mode Camera Browser Interface
AM18-Q0611 | v5.50 | 2012.03 Software manual Bosch Security Systems
5.3 Network
Use the settings on this page to integrate the device into a
network. Some changes only take effect after a reboot. In this
case, the Set button changes to Set and Reboot.
1. Make the desired changes.
2. Click Set and Reboot.
– The device is rebooted and the changed settings are
activated. If the IP address, subnet mask, or gateway
address is changed, then the device is only accessible
under the new addresses after the reboot.
DHCP
If the network has a DHCP server for dynamic IP address
allocation, set this parameter to On to activate the automatic
acceptance of DHCP-assigned IP addresses.
For certain applications, the DHCP server must support the
fixed assignment between IP address and MAC address, and
must be appropriately set up so that, once an IP address is
assigned, it is retained each time the system is rebooted.
IP address
Enter the desired IP address for the camera. The IP address
must be valid for the network.
Subnet mask
Enter the appropriate subnet mask for the set IP address.
Gateway address
Enter the IP address of the gateway to establish a connection to
a remote location in a different subnet. Otherwise, this field can
remain empty (0.0.0.0).
- Camera Browser Interface 1
- Table of Contents 3
- 1 Browser connection 10
- 1.3 Protected network 11
- 2 System Overview 12
- 3 Operation via the browser 13
- 3.1.2 Status icons 14
- 3.1.5 System Log / Event Log 16
- 3.1.6 Saving snapshots 17
- 3.1.10 Processor load 18
- 3.1.9 Audio communication 18
- 3.2 Recordings page 19
- 3.2.1 Controlling playback 20
- 4 Settings Overview 22
- 4.2 Settings 23
- 5Basic Mode 24
- 5.2 Date/Time 25
- 5.3 Network 26
- 5.4 Encoder 27
- 5.5 Audio 27
- 5.6 Recording 27
- 5.7 System Overview 27
- 6 Advanced General Settings 28
- 6.2 Password 29
- 6.3 Date/Time 30
- 6.3.5 Time server IP address 31
- 6.3.6 Time server type 31
- 6.4 Display Stamping 32
- 6.4.5 Alarm message 33
- 6.4.6 Video watermarking 33
- 7 Web Interface 34
- 7.2 LIVEPAGE Functions 35
- 7.2.7 Show system log 36
- 7.2.8 Allow snapshots 36
- 7.2.9 Allow local recording 36
- 7.2.10 I-Frame only stream 36
- 7.3 Logging 37
- 8 Camera 38
- 8.2 Picture Settings 39
- 8.2.2 Day/Night 40
- 8.3 Encoder Settings 41
- 8.4 Audio 42
- 8.5 Pixel Counter 42
- 9 Encoder Settings 43
- 9.1 Encoder Profile 44
- 9.1.3 Profile name 45
- 9.1.4 Target bit rate 45
- 9.1.5 Maximum bit rate 45
- 9.1.6 Encoding interval 45
- 9.1.8 Expert Settings 46
- 9.1.9 Default 47
- 9.2 Encoder Streams 48
- 9.2.2 JPEG stream 49
- 10 Recording 50
- 10.1 Storage Management 51
- 10.2 Recording Profiles 54
- 10.2.2 Standard recording 55
- 10.2.3 Alarm recording 55
- 10.3 Retention Time 57
- 10.4 Recording Scheduler 58
- 10.4.3 Profile names 59
- 10.4.4 Activate recording 59
- 10.4.5 Recording status 59
- 10.5 Recording Status 60
- 11 Alarm 61
- 11.1.5 Video transmission 62
- 11.1.6 Stream 62
- 11.1.7 Remote port 62
- 11.1.8 Video output 62
- 11.1.9 Decoder 62
- 11.1.10 SSL encryption 63
- 11.1.11 Auto-connect 63
- 11.1.12 Audio 63
- 11.3 Audio Alarm 65
- 11.4 Alarm E-Mail 66
- 11.4.8 Destination address 67
- 11.4.9 Sender name 67
- 11.4.10 Test e-mail 67
- 12 Setting up VCA 68
- 12.2 VCA - Profiles 69
- 12.2.2 Analysis type 70
- 12.2.3 Motion detector 70
- 12.2.4 Tamper detection 71
- 12.3 VCA - Scheduled 75
- 12.4 VCA - Event triggered 77
- 13 Interfaces 78
- 14 Network 79
- 14.1.3 IP V6 address 80
- 14.1.4 DNS server address 80
- 14.1.5 Video transmission 80
- 14.1.6 HTTP browser port 80
- 14.1.7 HTTPS browser port 80
- 14.1.8 RCP+ port 1756 81
- 14.1.9 Telnet support 81
- 14.1.10 Interface mode ETH 81
- 14.1.11 Network MSS [Byte] 81
- 14.1.12 iSCSI MSS [Byte] 81
- 14.1.19 Status 83
- 14.2 Advanced 84
- 14.2.5 RTSP port 85
- 14.2.6 UPnP 85
- 14.2.7 TCP metadata input 85
- 14.2.8 Quality of Service 85
- 14.3 Multicast 86
- 14.3.3 Port 87
- 14.3.4 Streaming 87
- 14.3.5 Multicast packet TTL 87
- 14.4 FTP Posting 88
- 14.5 IP V4 filter 89
- 15 Service 90
- 15.1.2 Configuration 91
- 15.1.3 SSL certificate 91
- 15.2 System Overview 92
- Bosch Security Systems 94
Produits connexes et manuels pour Systèmes de contrôle d'accès de sécurité Bosch FW5.50
(48 pages)
(24 pages)
(96 pages)© 2020, manymanuals.fr. Tous droits réservés | 1.227 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels