Bosch VG4-100 Series Manuel d'installation télécharger pdf (Page 40)

40 en | Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts VG4 Modular Camera Series

F.01U.162.025 | 6.0 | 2010.03 Installation Manual Bosch Security Systems, Inc.

7. Place the bubble support ring over the bubble and align the eight (8) captive screws with

the threaded inserts on the plastic gasket ring.

Figure 2.24 Attach Support Ring

8. Loosely tighten the captive screws with the T25 pin-in Torx tool using a diametrically

opposed tightening pattern, until the gap between the bubble support ring and the

housing closes.

Start tightening screw 1, then tighten screw 2. Next, tighten screw 3 and continue to

screw 4. Continue tightening the screws in this pattern.

Note: Make sure not to overtighten the screws.

Figure 2.25 Bubble Support Ring Tightening Pattern

1 2 ... 35 36 37 38 39 40 41 42 43 44 45 ... 107 108

Pas de commentaire

Bosch VG4-100 Series Manuel d'installation Page 40