Bosch VG4-100 Series Manuel d'installation télécharger pdf (Page 26)

26 en | Installing the Pendant Arm Wall, Corner, and Mast (Pole) Mounts VG4 Modular Camera Series

F.01U.162.025 | 6.0 | 2010.03 Installation Manual Bosch Security Systems, Inc.

5. Connect the incoming video coax cable to the BNC connector from the Pendant

Connector Harness and slide its plastic cover over the connector.

6. To connect alarm inputs and relay outputs, connect the 4-pin Alarms Out, the 6-pin

Alarms In and the 7-pin Relay connectors from the Pendant Connector Harness to their

mating connectors, installed previously, to the incoming alarm wires.

7. Connect the 3-pin Power In Plug, installed previously, to its matting connector P101 on

the left side of the box.

8. If installing a Fiber Optic model attach the incoming ST fiber plug, installed previously, to

its mating connector on the Fiber Optic Module in the power supply box. Then attach the

video BNC plug to its mating connector from the Pendant Connector Harness. See

Section 5 Cable and Wire Standards, page 85 for fiber optic specifications.

Figure 2.11 Optional Fiber Optic Module

1 Transformer 5 In/Out

2 BNC to Dome 6 ST Connector (Fiber)

3In/Out 7Power In

4 From Arm Harness 8 Data In/Out

(GND)

GND TXD

RXD 

C+

C-

(

FUSE)

(

FUSE)

(

FUSE

)

24V N

HTR DOME

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 107 108

Pas de commentaire

Bosch VG4-100 Series Manuel d'installation Page 26