Bosch ISW-BIT1-HAX WLSN INSTALLATION Spécifications télécharger pdf (Page 24)

wLSN | Reference Guide | 4.0 wLSN Hub

24 Bosch Security Systems, Inc. | 3/07 | F01U009440-01

4.1 wLSN Hub Switches

Use Switches S1, S2, and S3 located on the wLSN Hub’s inner

cover to configure the device’s operation or to enable special

diagnostic or installation modes.

Figure 3: Switches

S1 S2 S3

Assign a different address to each option bus device.

wLSN Hub choices are S1=1 and S1=2.

Switch one (S1) configures the wLSN Hub’s address on the option

bus. To configure the switches for normal operation set S1 to 1 or

2. For programming information at the control panel, refer to the

control panel’s documentation. Set Switch 2 (S2) and Switch 3

(S3) to 0 (zero).

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 59 60

Pas de commentaire

Bosch ISW-BIT1-HAX WLSN INSTALLATION Spécifications Page 24