Bosch ISW-BIT1-HAX WLSN INSTALLATION Spécifications télécharger pdf (Page 14)

wLSN | Reference Guide | 2.0 General Installation

14 Bosch Security Systems, Inc. | 3/07 | F01U009440-01

Reset the wLSN Hub’s DIP switches to their original

settings to exit RFSS mode. Refer to Section 2.4.1

Preparing the wLSN Hub for Site Testing and RFSS Mode

on page 11.

To cause a device to exit RFSS mode, remove the

device's batteries and re-insert them. Devices

automatically exit RFSS mode after 10 min of inactivity.

2.4.3 RFSS Testing Between wLSN Hub and Installation Tool

You must test the devices at the same EN50131 Security

Grade at which the control panel discovers the devices.

The LCD Display is 2 lines by 16 characters. The LCD display

flashes and beeps the sounder every 4 sec with each information

update.

1. Take the Installation Tool to the device’s planned mounting

location.

2. Press any key on the Installation Tool to awaken it.

WSNINSTAL

Vx. x

TOO

3. Press and hold the [*] and [#] key together to enter RFSS

mode. The LCD display shows:

To select a mode, press its numerical key, for example, press

[2] for Mode 2.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 59 60

Pas de commentaire

Bosch ISW-BIT1-HAX WLSN INSTALLATION Spécifications Page 14