Bosch PR10E Manuel d'utilisation et d'entretien télécharger pdf (Page 8)

COLLET CHUCK CARE

With the router bit removed, continue to turn

the collet chuck counter-clockwise until it is

free of the shaft. To assure a firm grip,

occasionally blow out the collet chuck with

compressed air, and clean the taper in the

armature assembly shaft with a tissue or fine

brush. The collet chuck is made up of two

component parts that snap together (Fig. 4);

check to see that the collet is properly seated

in the collet chuck nut and lightly thread the

collet chuck back onto the armature shaft.

Replace worn or damaged collet chucks

immediately.

REMOVING MOTOR FROM BASE

1. Open the clamping lever (Fig. 5).

2.

Turn the motor so that the single triangle

on the base lines up with “unlocked”

symbol on the motor. (Make sure that the

indication the base is aligned with the line

under the “unlocked” symbol on the motor.

Otherwise, the router can be damaged.)

(Fig. 5)

3. Pull the motor away from base until it stops

(Fig. 5).

4. Turn motor counterclockwise until it stops

(Fig. 6).

5. Pull motor out of base (Fig. 6).

-8-

2

1

3

Collet

Collet

Chuck

Nut

F

IG. 4

FIG. 5

1

5

4

FIG. 6

BM 2609140306 09-05 10/5/05 8:12 AM Page 8

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 63 64

Commentaires sur ces manuels

Pas de commentaire