Bosch PR10E Manuel d'utilisation et d'entretien télécharger pdf (Page 19)

-19-

PR007 SIDE-HANDLE SUBBASE

(Available as optional accessory)

See PR007 instruction sheet for complete

information about this accessory.

The PR007 Side-Handle Subbase and Dust

Extraction Kit (Fig. 33) is a versatile

accessory that provides several useful

features:

• Additional means of supporting the router

• Ability to use various templet guide

bushings

• Dust extraction and collection capability

PR007 Attachment to Palm Router

1. Remove regular subbase

2. Attach side handle subbase with the

panhead screws that are included with it.

Additional Means of Supporting

the Router

The knob handle on the PR007 subbase

provides an additional gripping point for the

palm router / side-handle subbase assembly.

It is designed for use when the palm routers

are being used in applications that are wide

enough that the knob sits over the workpiece.

Holding the knob and keeping it pressed

down over the workpiece helps keep the

routers’ angle to the workpiece unchanged,

and is especially helpful when routing edges.

Templet Guide Usage

The PR007 Side-Handle Subbase accepts

the Bosch RA-Series Templet Guide

Adapters.

Attachment of Templet Guide to

Side-Handle Subbase

1. Remove regular subbase

2. Insert templet guide into top of round

subbase.

3. Loosely attach side handle subbase using

panhead screws that come with that

accessory.

4. Center the templet guide around the bit.

(The optional Bosch RA1150 Centering

Cone can be used to ensure that the

templet guide is properly centered.)

5. Tighten the panhead screws to hold the

templet guide and subbase in position.

Note: Conventional threaded templet guides

can be used with the PR007 if the optional

RA1100 Adapter for Threaded Templets is

also used.

Attachment of PR006 Underscribe

Attachment

The PR006 Underscribe Attachment can also

be used with the palm router and the side-

handle subbase.

Note: When the underscribe attachment is

used with the side-handle subbase, the

longer set of attachment screws should be

used.

Please refer to PR006 Underscribe

Attachment section for further instructions.

Dust Extraction & Collection Capability

If you have a shop vacuum system, you can

connect it to the PR007’s dust extraction

FIG. 33

3. The overlapping piece of laminate should

overlap the guiding piece by about 1/2".

(The overlapping sheet of laminate will

then pass over the aluminum plate and be

cut at the proper point by the router bit.)

4. Keep steady pressure on the tool so that

t

he guiding edge of the base remains in

contact with the fixed piece of laminate

throughout the operation. This is especially

important at the beginning and end of a

cut.

5. It is also necessary to keep the laminate

pressed down tightly near the seam to

keep these chips from getting under the

laminate. This is especially important on

larger pieces of material. The optional

PR007 Side Handle Subbase includes a

dust extraction hood port that connects to

a

vacuum hose and helps to keep chips

from getting under the laminate.

BM 2609140306 09-05 10/5/05 8:12 AM Page 19

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 63 64

Commentaires sur ces manuels

Pas de commentaire